Clean Your Grooves Before Every Shot

Disclosure: Some links on this page are affiliate links. If you buy through them we may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Learn more.
The grooves on your irons and wedges aren’t decoration. Their job is to channel grass, dirt and water away from the spot where the clubface meets the ball, so the face can grip the cover and create spin. Pack them with dirt and they can’t do that job. Golf Digest tested it with a 60-degree wedge and a launch monitor from 100 yards: after taking a divot and not cleaning the face, spin dropped from just over 10,500 rpm to about 5,760, nearly half. That lost spin matters most on short shots, where you need the ball to check instead of releasing past the hole. The fix takes two seconds. Clip a groove brush or a towel to your bag, and after every shot that takes a divot or comes out of the rough, scrub the grooves clean, then wipe the face dry before your next swing. Top teacher Trillium Rose tells GOLF.com that clean, dry grooves are a key ingredient for spin, and on dewy or wet mornings, drying the face counts as much as cleaning it.
🛒 Gear that helps with this: Frogger Amphibian Golf Towel — A wet/dry towel that clips to your bag. Clean grooves before every wedge for more spin.
Why it works
Try it on your next range session, then take it to the course. Small, repeatable habits like this add up to lower scores.
🛒 Many golfers practice this with Cleveland RTX ZipCore Wedge — A spin-focused wedge offered in multiple lofts and grinds, so you can match bounce to your turf.
Watch it
Spin Test – Clean Wedge VS Dirty Wedge — Club Champion
Sources & further reading
- Clean vs. dirty clubface grooves: a spin-rate test · Golf Digest
Launch-monitor test with a 60-degree wedge from 100 yards: spin fell from about 10,550 rpm with clean grooves to about 5,760 after a divot left them dirty; grooves channel moisture and debris away from impact. - Equipment mailbag: How important is it to clean your wedge grooves? · Golf Digest
Debris in the grooves reduces spin; an inexpensive groove brush takes a couple of seconds after each shot. - 3 hacks to add more spin to your wedge shots · GOLF.com
Top 100 Teacher Trillium Rose: keep the clubface grooves clean and dry to help generate spin.
FAQ
What is the "Clean Your Grooves Before Every Shot" golf tip?
The grooves on your irons and wedges aren’t decoration. Their job is to channel grass, dirt and water away from the spot where the clubface meets the ball, so the face can grip the cover and create spin. Pack them with dirt and they can’t do that job. Golf Digest tested it with a 60-degree wedge and a launch monitor from 100 yards: after taking a divot and not cleaning the face, spin dropped from just over 10,500 rpm to about 5,760, nearly half.
What else should I know about it?
That lost spin matters most on short shots, where you need the ball to check instead of releasing past the hole. The fix takes two seconds. Clip a groove brush or a towel to your bag, and after every shot that takes a divot or comes out of the rough, scrub the grooves clean, then wipe the face dry before your next swing. com that clean, dry grooves are a key ingredient for spin, and on dewy or wet mornings, drying the face counts as much as cleaning it.
Ready to practice this? Our top pick for this tip is the Frogger Amphibian Golf Towel.